X
H+H SCR Technology for lower NOx emissions

How is the reducing agent ammonia brought into the SCR system?

The ammonia (NH3) necessary for selective catalytic reduction can be injected into the exhaust gas stream in a variety of
ways. The most common way is the transformation and injection of urea solutions. Depending on the plant, ammonia can
also be injected directly. The injection itself can also take place in different forms. 

How does the injection of pure ammonia work?

If ammonia is injected directly, it must be available on site in gas bottles. This method can be used especially for low ammonia
requirements, if the storage and installation of gas cylinders is not a problem. For this purpose, a dosing unit is installed which
monitors and controls the pressure and flow of the system.

How can ammonia also be dosed?

If larger quantities of ammonia are required for the reduction of NOx, it can be added as ammonia water. After dosing, ammonia can
evaporate very quickly from the solution. However, high safety requirements are necessary when using ammonia water, as ammonia
can evaporate during storage and form explosive and toxic mixtures. The other possibility is the use of urea solutions. The urea solution
can be dried by the hot exhaust gas and urea can then be melted. Water and ammonia are formed in the process. This method allows
ammonia to be stored in urea, so to speak, even in large quantities. Only the conversion of the urea into ammonia must be guaranteed
by a sufficient evaporation length.

How is the injection technically implemented?

In principle, the urea or ammonia solutions can be injected in two ways. On the one hand directly by special injectors with
(the necessary) precise actuators, or compressed air supported by appropriate atomizers. The former technique is suitable
for low reducing agent requirements and is usually accompanied by higher urea droplet size and the resulting longer evaporation
time. With compressed air-supported injection, smaller droplet diameters can be achieved, and the evaporation is correspondingly
faster, even with high ammonia requirements.

» Learn more

In this case, a more complex dosing unit is required, which additionally monitors and regulates the compressed air flow.
Specially designed mixing units then ensure optimum distribution of the ammonia in the system. In very large systems,
such as gas turbines, the injection can also be carried out via a bypass. Part of the flue gas flow is extracted, ammonia is
injected and mixed and then returned to the flue gas stream via an "Ammonia Injection Grid". By means of CFD analysis,
an optimum ammonia distribution can be set for each system.

Substantial Expericence

Personal and reliable

Our service engineers have been working for more than 30 years in the field
of exhaust gas and air treatment technology. Should you have any question,
we would be pleased to support you.